2000 Fiat Punto

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emits dense blue smoke at idle (7.3.A.2b)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Headlamp aim too low (1.8)

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front Brake pipe slightly corroded (3.6.B.2c)

heavy corrosion bonnett

heavy corrosion rear boot floor and holed and bumper supports

heavy under seal under car

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Front suspension ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside front brake binding (3.7.B.1)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Headlamp aim too low (1.8)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Inner Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Inner Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear coil spring corroded (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear parking brake recording little or no effort (3.7.B.6a)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear coil spring corroded (2.4.C.1b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear coil spring corroded (2.4.C.1b)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Rear coil spring corroded (2.4.C.1b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Headlamp aim too low (1.8)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear coil spring corroded (2.4.C.1b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Engine/gearbox mounting(s) defective

front lower ball joints dust cover split (no excessive movement at time of test)

Nearside Front Brake hose slightly damaged (3.6.B.4d)

entire underside of vehicle is showing early signs of corrosion

front of engine sump is very corroded