1999 Aprilia RS125

Rear tyre cracking

Front Wheel fractured at bridge over valve (5.2.2 (a))

Fuel pipe damaged but not to excess Fuel Pipe To Carb Not Fitted Correctly (6.1.3 (c) (ii))

Offside Rear Brake lever worn, but not excessively (1.1.15 (b))

Rear Drive chain sprocket slightly loose Sprocket Hub Has Play (6.1.7 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Offside Lower Fairings Missing a bolt

Front Position lamp not working Front Side Light Not Working (4.2.1 (a))

Front Throttle operating incorrectly (6.2.7 (a) (i))

Rear Stop lamp not working Rear Brake Light Not Working (4.3.1 (a) (ii))

Rear Stop lamp not working Rear Side Light Not Working (4.3.1 (a) (ii))

Rear Brake caliper insecurely mounted and braking performance affected Rear Caliper Mounted On Top Should Be Underneath (1.1.16 (c) (ii)) DANGEROUS

Front Wheel fractured at bridge over valve (5.2.2 (a))

Fuel pipe damaged but not to excess Fuel Pipe To Carb Not Fitted Correctly (6.1.3 (c) (ii))

Offside Rear Brake lever worn, but not excessively (1.1.15 (b))

Rear Drive chain sprocket slightly loose Sprocket Hub Has Play (6.1.7 (c) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Offside Lower Fairings Missing a bolt

Front Tyre worn close to the legal limit (5.2.3 (e))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Position lamp not working (4.2.1 (a))

Drive chain sprocket carrier worn but not considered excessive (6.2.1e)

front brake binding slightly

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp aim too low (1.6)

Rear Brake pipe union leaking fluid (3.2.B4)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Drive chain sprocket carrier worn but not considered excessive (6.2.1e)

front brake binding slightly

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Horn not working (1.7.3a)

Offside Front Direction indicators not working (1.5.1c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Steering control handlebar movement restricted by trapped cables (2.1.2c)

Stop lamp does not illuminate immediately a brake applies Rear Brake Pedle (1.3.1a)

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

Nearside Rear Footrest missing (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Rear Brake pipe inadequately supported (3.2.B2b)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Wheel alignment incorrect which adversely affects the handling (2.5.1)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Roller brake test indicates a slightly grabbing brake (3.3.A1b)