1999 Honda Accord

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake performance unable to be tested (1.2.1 (g))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill/floor (5.3.6 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor/sill (7.1.1 (a) (i))

Fuel Pipe/s corroded ()

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

both sills corroded

sill covers fitted not allowing full inspection of outer sills

various parts of underside corroded

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive arch (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive arch (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear boot floor corroded

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive arch (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive arch (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear boot floor corroded

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor section (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor section (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

near side rear brake back plate missing

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

near side rear brake back plate missing

rear brake discs badly pitted and corroded

light corrosion on off side rear inner sill outwith prescribed areas

rear brake discs corroded and pitted

Nearside Registration plate lamp not working (1.1.C.1d)

light corrosion on off side rear inner sill outwith prescribed areas

rear brake discs corroded and pitted

rear brake discs corroded and pitted

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Braking system leaking (3.6.A.1) DANGEROUS

rear brake discs corroded and pitted

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Rear Brake pipe leaking (3.6.A.1) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

near side rear brake disc pitted and corroded.

Brakes imbalanced across an axle (3.7.B.5b)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Registration plate lamp not fitted (1.1.C.1b)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear brake drum worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

engine sump corroded and leaking oil.

Nearside Headlamp aim too high (1.8)

engine sump corroded and leaking oil.

Nearside Front All position lamps not working (1.1.A.3b)

Nearside Front front brake binding (3.7.B.1)

Offside Front front brake binding (3.7.B.1)

rear brake discs badly corroded

Nearside Front Anti-roll bar linkage fractured (2.4.G.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)