2000 Vauxhall Corsa

Brake performance not tested (1.2.1 (g))

Emissions not tested (8.2.1.2 (d))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Axle deformed and unserviceable (5.1.1 (a)) DANGEROUS

Offside Rear Suspension component corroded and seriously weakened Axle (5.3.3 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner and outer sills N/S and O/S (5.3.6 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Lower arm inner mount area (5.3.6 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material N/S and O/S (1.1.11 (c))

Vehicle is heavily undersealed.

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Lower arm inner mount area (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material N/S and O/S (1.1.11 (c))

Vehicle is heavily undersealed.

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear axle beam rusty but not holed.

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill also arch (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch and inner sill (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Brake pipe corroded, covered in grease or other material all rear pipes (1.1.11 (c))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension component corroded but not seriously weakened rear axle (5.3.3 (b) (i))

brake travel on foot pedal but effiency ok

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Nearside Front tyre slightly perished.

Rear axle beam corroded but not weaken.

Central Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc clip broken (2.5.C.1a)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Nearside Front tyre slightly perished.

Rear axle beam corroded but not weaken.

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Obligatory mirror missing (8.1.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Surface corrosion affecting rear chassis around suspension areas

Nearside Rear Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Centre Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear wheel bearing has excessive play (2.6.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Brake hose slightly deteriorated (3.6.B.4d)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)