2003 BMW Z4

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Hydraulic brake calliper insecurely mounted clip (1.1.16 (c) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Brake hose slightly twisted (1.1.12 (b) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Emissions oxygen sensor obviously defective (8.2.1.1 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Hydraulic brake calliper insecurely mounted outer clip. (1.1.16 (c) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Tyre worn close to legal limit/worn on edge both fronts. (5.2.3 (e))

Offside Front Brake hose slightly twisted and not supported on strut mounting clip. (1.1.12 (b) (i))

Rear Brake pipe corroded, covered in grease or other material all rear upper and outers. (1.1.11 (c))

Rear Oil leak, but not excessive rear diff, from both driveshaft seals. (8.4.1 (a) (i))

Rear Road wheel slightly distorted both rears. (5.2.2 (c) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement all bushes. (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Inner Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Headlight lens cloudy but beam pattern ok

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Inner Road wheel slightly distorted (5.2.2 (c) (i))

Offside Front Headlight lens cloudy but beam pattern ok

Fuel cap seal perished

Rear tyres worn on inner edges

fuel cap seal perished

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) wearing thin (3.5.1g)

brake pad warning light illuninated at time of test

osr tyre worn very low inner edge

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

engine oil found on minimum

front service brake imbalance seems high

front service brake pads look low?

parking brake will not go to lock-out

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front tyres heavily worn inner edges

o/s headlamp condensated and poor beam image

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front tyres heavily worn inner edges

o/s headlamp condensated and poor beam image

Horn not working (1.6.2a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)