2000 Peugeot Boxer

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Stop lamp excessively damaged so that it is not visible from a reasonable distance (1.2.1d)

Nearside Stop lamp emits other than a steady red light (1.2.1e)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Stop lamp not working (1.2.1b)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Offside Front Brake pipe slightly corroded (3.6.B.2c)

n/s o/s/r suspension bump stops worn

o/s door checkstrap defective

o/s/f top suspension mounting stiff

n/s side door handle broken

Offside Front Brake pipe slightly corroded (3.6.B.2c)

n/s rear lamp has been repaired

n/s reverse light not working

some play in o/s steering rack arm

Brake pedal anti-slip provision worn smooth (3.3.A.1b)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Side repeater not working (1.4.A.2c)

Offside Stop lamp excessively damaged so that it is not visible from a reasonable distance (1.2.1d)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

n/s rear lamp has been repaired

n/s reverse light not working

n/s side door handle broken

some play in o/s steering rack arm

Brake pipe excessively corroded (3.6.B.2c)

Brake relay lever has restricted free movement (3.5.1k)

Exhaust mounting missing (7.1.1b)

Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Front registration plate letter/figure incomplete (6.3.1c)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Service brake indicates brake bind (3.7.D.2a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Registration plate lamp not working (1.1.5c)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

both handbrake cables split (outers)

Centre Exhaust mounting missing (7.1.1b)

Nearside Headlamp aim too low (1.8)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Headlamp aim too low (1.8)

Offside Stop lamp not working (1.2.1b)

Service brake: efficiency below requirements (3.7.D.4)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Suspension arm has slight play in a track control arm inner bush (2.5.B.2b)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear wheel bearing has slight play (2.6.2)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Coil spring not correctly located (2.4.C.2)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Registration plate lamp flickers when tapped lightly by hand (1.1.5e)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Stop lamp not working (1.2.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Steering system excessively rough (2.2.D.1)

Windscreen washer provides insufficient washer liquid (8.2.3)