2000 Ford Mondeo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Windscreen washer not working (3.5 (a))

Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Bumper damaged

oil leak adjacent to engine/gearbox

n/s/r brake pipe to hose behind fuel tank deteriorating

o/s/r tyre worn inner edge

rear roll bar rubbers perished

rear shocks wearing

slight exhaust blow from cat

spare wheel well corroded

Front Anti-roll bar linkage ball joint excessively worn both (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

n/s/r brake pipe to hose behind fuel tank deteriorating

o/s/r tyre worn inner edge

rear roll bar rubbers perished

rear shocks wearing

slight exhaust blow from cat

spare wheel well corroded

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Track rod end ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii))

unable to fully view all underside brake pipes due to vehicle design

Front Direction indicator incorrect colour Both (1.4.A.2f)

Front registration plate deteriorated (6.3.1d)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

all tyres under inflated

unable to fully view all underside brake pipes due to vehicle design

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Engine covers fitted obscuring some components in the engine bay

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Under-trays fitted obscuring some underside components

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

Under-trays fitted obscuring some underside components

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

off side rear tyre slight cracking

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Rear Registration plate lamp not working (1.1.C.1d)

off side rear tyre slight cracking

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake pad(s) wearing thin (3.5.1g)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front brake disc slightly pitted (3.5.1h)

Rear Brake pipe slightly corroded (3.6.B.2c)

Power steering pump has slight seepage from a component (2.3.3b)

brake disc slightly pitted (3.5.1h)