1999 Mercedes-benz Vito

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Horn not working (7.7 (a))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced Corrosion all underside of vehicle (6.1.1 (c) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill back (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill back (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

corrosion on front chassis legs

corrosion on rear brake pipes

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

corrosion on front chassis legs

corrosion on rear brake pipes

Horn not working (1.6.2a)

Nearside Front Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Macpherson strut severely distorted BOLTS LOOSE (2.4.G.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings SILL END (6.1.B.2)

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear Body or chassis has an inadequate repair, seriously affecting its strength within 30cm of the body mountings SILL END (6.1.B.2)

Offside Rear rear brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

Advise front tyres worn inner edges

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension arm has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

slight play in o/s rack arm

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Registration plate lamp not working (1.1.5c)

Offside Stop lamp not working (1.2.1b)

Offside Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)