1999 Honda Accord

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen washer not working (3.5 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced centre sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Play in steering rack inner joint(s) ()

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement d bush (5.3.4 (a) (i))

Power steering component has slight seepage from a component rack (2.1.5 (a))

Power steering pipe/hose has slight seepage (2.1.5 (a))

vehicle underside corroded

Direction indicator slightly discoloured indicator bulbs, amber coating wearing off, both rear ones and osf (4.4.3 (a))

Offside Rear Tyre slightly damaged/cracking or perishing tyre starting to crack in tread grooves (5.2.3 (d) (ii))

Play in steering rack inner joint(s) tie rods have slight play ()

Rear Brake disc worn, pitted or scored, but not seriously weakened both rear discs, inner pads only working on part of the disc, suspect caliper piston isnt in the correct mounting position for the pad pegs, advise to repair. (1.1.14 (a) (ii))

engine oil on min

fuel pipes corroded, front to rear sections

rear service and parking brake performance passed the test but readings should be better, advise to rectify rear brake issue.

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced hole in rear end of sill (6.1.1 (c) (i))

Power steering malfunctioning loose PAS belt, causes intermittent loss of assistance when cold, or on full lock. new belt required/tighten existing one. (2.1.5 (a))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced corrosion to chassis, both sides, near front subframe mounts (6.1.1 (c) (i))

Direction indicator slightly discoloured indicator bulbs, amber coating wearing off, both rear ones and osf (4.4.3 (a))

Offside Rear Tyre slightly damaged/cracking or perishing tyre starting to crack in tread grooves (5.2.3 (d) (ii))

Play in steering rack inner joint(s) tie rods have slight play ()

Rear Brake disc worn, pitted or scored, but not seriously weakened both rear discs, inner pads only working on part of the disc, suspect caliper piston isnt in the correct mounting position for the pad pegs, advise to repair. (1.1.14 (a) (ii))

engine oil on min

fuel pipes corroded, front to rear sections

rear service and parking brake performance passed the test but readings should be better, advise to rectify rear brake issue.

Plastic sill covers fitted obscuring some testable items.

Brake pipe corroded, covered in grease or other material pipes coated to protect. (1.1.11 (c))

Rear both tyres worn on the inner edges

Plastic sill covers fitted obscuring some testable items.

Front brake discs worn.

Plastic sill covers fitted obscuring some testable components.

o/s rear tyre perishing

both front chassis rails corroding

front to rear fuel pipes corroding in plastic covers

N/S rear tyre worn inner edge

n/s rear brake starting to bind

Rear Brake pad(s) wearing thin (3.5.1g)

Brake pad(s) wearing thin (3.5.1g)