1999 Honda Accord

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

both rear brake pipes showing signs of deterioration

slight leak o/s/f shock absorber

Emissions not tested (7.3.A.1)

Nearside Front Headlamp aim too high (1.8)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

both rear brake pipes showing signs of deterioration

front brake pads low

slight leak o/s/f shock absorber

Non obligatory mirror damaged

Offside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Non obligatory mirror damaged

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Headlamp not working on dipped beam (1.7.5a)

offside rear brake pipe getting badly corroded

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

plastic covering both outer sill panels