2004 MG Zt

Front Windscreen washer not working (3.5 (a))

Nearside Rear Exhaust mounting defective clamp (6.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength subframe cross beam holed (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing Arm (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Trailing Arm (5.3.4 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Outer Seat belt anchorage prescribed area is inadequately repaired Sill (7.1.1 (a) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Prop shaft flexible coupling excessively deteriorated (6.1.7 (d) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing Arm (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Trailing Arm (5.3.4 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength SILL (5.3.6 (a) (i))

both rear tyres wearing on inner edges

slight corrosion to all brake discs due to vehicle being stood

brake pad warning light on dash

Offside Front Headlamp aim too high (1.8)

brake pad warning light on dash

advise air bag light flashed then went off

Driver's airbag obviously defective (5.4.1)

Rear Body has a projection caused by corrosion (6.1.C.1)

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)