2000 Hyundai Accent

EML warning lamp on

both front brake pipes corroded at inner wing grommet

both outer c.v. gaiters deteriortated

front discs corroded on inner face

imbalance on front brakes

noise n/s/f wheel , suspect bearing

o/s/f suspension lower ball joint seal insecure

wheel trims fitted , retsricted views

Nearside Body has a sharp edge caused by damage (6.1.C.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Seat belt retracting mechanism defective (5.2.5b)

Parking brake lever has no reserve travel (3.1.6b)

Offside Rear Mechanical brake component has restricted free movement (3.5.1k) DANGEROUS

EML warning lamp on

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low and too far to the right. (1.8)

both front brake pipes corroded at inner wing grommet

both outer c.v. gaiters deteriortated

front discs corroded on inner face

imbalance on front brakes

noise n/s/f wheel , suspect bearing

o/s/f suspension lower ball joint seal insecure

unable to spin check o/s/r wheel bearing due to binding brake

wheel trims fitted , retsricted views

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Non obligatory mirror damaged

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

engine management light on

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Non obligatory mirror damaged

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Spare tyre defective

engine management light on

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Parking brake lever has little reserve travel (3.1.6b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

park brake travel long

park brake travel high

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

engine management light on

park brake travel high

slight marks on front and rear number plates

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear Registration plate lamp not working (1.1.5c)

rear brake application uneven (3.7.B.2)

hand brake as long travle, rear brakes may be in need of service ?

slight marks on front and rear number plates

Nearside Headlamp aim too high and too far to the right. (1.8)

Nearside Headlamp not working on dipped beam (1.7.5a)

front brake pads two thirds worn

front no plate slightly disfigured

front brake pads two thirds worn

front no plate slightly disfigured

Offside Front Headlamp not working on dipped beam (1.7.5a)