2000 Mazda Bongo

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Inner sill has massive hole but outside prescribed area

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Inner sill has multiple holes but is outside prescribed area

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Inner sill has massive hole but outside prescribed area

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Inner sill has multiple holes but is outside prescribed area

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front crossmember corroded.

Offside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Radiator crossmember corroded.

Service brake fluctuating, but not excessively Both sides front (1.2.1 (e))

Tyre slightly damaged/cracking or perishing Both sides rear (5.2.3 (d) (ii))

Central Exhaust has a major leak of exhaust gases Flexible section (6.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Radiator crossmember corroded.

Service brake fluctuating, but not excessively Both sides front (1.2.1 (e))

Tyre slightly damaged/cracking or perishing Both sides rear (5.2.3 (d) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Outer sill (5.3.6 (a) (i))

Tyre slightly damaged/cracking or perishing Both rear tyres perished (5.2.3 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

Front Tyre tread depth below requirements of 1.6mm both tyres (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (2.4.A.3)

Nearside Front Outer Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Inner Tyre worn close to the legal limit edge (4.1.E.1)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Outer Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Inner Tyre worn close to the legal limit edge (4.1.E.1)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear fog lamp not working (1.3.2b)

advise ---- second hand front brake hoses fitted in servicable condition

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Rear fog lamp not working (1.3.2b)

advise --- nearside wiper blade is in a poor condition

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

advise ---- front brakes are unbalanced

advise ==== slight exhaust gas leak

Brake pad(s) wearing thin (3.5.1g)

both front tyres worn low on edges of tread

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Rear fog lamp missing (1.3.2a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)