2007 Mitsubishi Lancer

Brake pipe excessively corroded Both front to rear at rear (1.1.11 (c))

Front Brake pipe excessively corroded Both (1.1.11 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Windscreen wiper does not clear the windscreen effectively Both (3.4 (b) (ii))

Offside Rear Brake pad(s) less than 1.5 mm thick On metal (1.1.13 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases Front flexi and rear box (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Fuel filler neck corroded through

General corrosion underneath - suspension arms, subframes etc.

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Rear some deterioration at both n/s and o/s rear suspension lower /outer joints

Rear some rust at both rear wheel arches --- not excessive

some deterioration and slight blowing at front and rear exhaust -- not excessive

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear fog lamp not working and lens broken (1.3.2b)

Front Anti-roll bar linkage has slight play in a pin/bush both sides --- not excessive (2.4.G.2)

Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Rear some deterioration at both n/s and o/s rear suspension lower /outer joints

Rear some rust at both rear wheel arches --- not excessive

some deterioration and slight blowing at front and rear exhaust -- not excessive

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear fog lamp damaged, but still visible from a reasonable distance (1.3.2d)

exhaust deteriorating -- not yet excessive

slight wear at n/s/front wheel bearing

Nearside rear disk badly pitted.

Rust forming on rear hose ferrules and rear brake pipes.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear disk badly pitted.

Rust forming on rear hose ferrules and rear brake pipes.

Handbrake lever close to full extent of travel.

Offside rear brake disk pitted

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)