2007 Toyota Land Cruiser

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Front Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Fuel Pipe/s corroded ()

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Oil leak ()

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc Inner (2.5.C.1a)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Front Oil leak ()

Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Registration plate lamp not fitted (1.1.C.1b)

Offside Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Brake performance not tested (3.7.A.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too low (1.8)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Registration plate lamp not working (1.1.C.1d)