2002 Nissan Cube

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear fog lamp

Offside Rear Rear fog lamp with a multiple light source up to 1/2 not functioning (4.5.1 (a) (i))

Towball/hitch not fitted at time of test ()

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Rear fog lamp with a multiple light source up to 1/2 not functioning (4.5.1 (a) (i))

Towball/hitch not fitted at time of test ()

Nearside Front tyre cracking on inner wall

Offside Front tyre cracking on inner wall

Rear Rear fog lamp has light sources not illuminating, but not more than 50% (1.3.2b)

Rear fog lamp has light sources not illuminating, but not more than 50% (1.3.2b)

Rear registration plate obscured (6.3.1d)

Rear fog lamp has light sources not illuminating, but not more than 50% (1.3.2b)

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

nearside rear tyre treads cracking not to cords

park brake has little reserve travel

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres side walls perishing

nearside front tyre outer wall persing

slight play in nearside inner rack joint

Child seat fitted not allowing full inspection of adult belt

Nearside Inner Track rod end ball joint has slight play (2.2.B.1f)