2003 MG Zt

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

slight engine oil leak

slight surface corrosion on underside of vehicle

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Power steering pump has slight seepage (2.1.5 (a))

general under body corrosion

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm rear bush ( both ) (5.3.4 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement arm rear bush ( both ) (5.3.4 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Brake pad(s) wear indicator illuminated (1.1.13 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

both front brake pipes rusty

both rear tyres wearing uneven

Central Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Emissions not tested due to exhaust blow (7.3.A.1)

Exhaust has a major leak of exhaust gases rear box (7.1.2)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt drop-link (2.4.G.2)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt drop-link (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear coil spring broken (2.4.C.1a)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

both front brake pipes rusty

both rear tyres wearing uneven

Front Headlamp aim beam image obviously incorrect both (1.8.A.1b)

Parking brake: efficiency below requirements (3.7.B.7)

exhaust very rusty

handbrake performance low

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both rear tyres going out of shape

exhaust rusty

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both rear tyres going out of shape

exhaust rusty

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

both front tyres close to tread wear indicators in centre section of tyre

offside rear tyre close to tread wear indicators

both rear brake discs corroding not excessive yet

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

rear brake discs corroding (not excessive yet)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

nearside rear brake disc corroding (not excessive yet)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Front Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear Registration plate lamp not working (1.1.5c)