2006 Toyota Aygo

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Front Lower Suspension arm corroded but not seriously weakened x2 nearside and offside (5.3.3 (b) (i))

Front Macpherson strut corroded but not seriously weakened x2 nearside and offside (5.3.3 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Sub-frame damaged but not seriously weakened (5.3.3 (b) (i))

Offside Rear Outer Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material nearside and offside (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement x2 nearside and offside (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive all rear areas (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced throughout underside (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Headlamp aim unable to be tested (4.1.2 (b))

Main beam tell-tale not working remaining on with lights (4.9.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Front Lower Suspension arm corroded but not seriously weakened x2 nearside and offside (5.3.3 (b) (i))

Front Macpherson strut corroded but not seriously weakened x2 nearside and offside (5.3.3 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Sub-frame damaged but not seriously weakened (5.3.3 (b) (i))

Offside Rear Outer Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material nearside and offside (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement x2 nearside and offside (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive all rear areas (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced throughout underside (6.1.1 (c) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill area (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust mounting defective (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened Both (5.3.3 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Bumper not fully clipped in

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Temp repair exhaust.

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Front Exhaust silencer insecure (8.1.1 (b) (i))

Headlamp has a product on the lens so that the light output is severely reduced both (4.1.4 (b))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Position lamp adversely affected by the operation of another lamp bulb fitted incorrectly (4.2.3 (c))

Rear Registration plate insecure (0.1 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Tyre obviously under inflated (5.2.3 (l))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Brake hose slightly deteriorated (1.1.12 (b) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Inner Suspension component mounting prescribed area is corroded but not considered excessive Sills (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output both front (4.1.4 (b))

Rear Sub-frame pin or bush worn but not resulting in excessive movement both rear bushes (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened pitted (3.5.1i)

Offside rear brake binding (3.7.B.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

nearside rear tyre worn on edges

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Stop lamp not working (1.2.1b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)