1982 Austin Mini 1000 Hl E

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

fuel pipe corroded

offside front outer constant velocity joint boot deteriorated

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Brake hose excessively twisted (1.1.12 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

body corroded

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Windscreen washer not working (3.5 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Hazard Switch Not Working

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material From T Piece To Flexi (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Rear Rear fog lamp does not emit a steady red light (4.5.4 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced both front sills (6.1.1 (c) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

surface rust and black paint coating under the vehicle and on some components

Offside Front Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

surface rust under the vehicle and on some components

Oil leak

o s rack arm slight play at its fixing

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)