2004 Jaguar X-type

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both rear inner edges (5.2.3 (e))

heavily wax-oiled preventing full inspection of some underside components

Front All direction indicators incorrect colour (4.4.3 (a))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Lower Shock absorbers has an excessively worn bush (5.3.2 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i))

Offside Rear Lower Shock absorbers has an excessively worn bush (5.3.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Power steering malfunctioning Only works when vehicle is reved (2.1.5 (a))

Rear All direction indicators incorrect colour (4.4.3 (a))

Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Manufactures engine and body covers fitted restricting inspection of components

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material 2X brake pipes over subframe rusty (1.1.11 (c))

Offside Rear Fuel filler pipes damp

Offside Rear Hole in fuel tank mounting bracket.

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear wishbones (5.3.6 (a) (i))

advise sill covers and under trays fitted

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear subframe (5.3.6 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear wishbones (5.3.6 (a) (i))

advise sill covers and under trays fitted

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

plastic sill covers fitted

Nearside Lower Seat belt anchorage prescribed area strength or continuity significantly reduced at sill (7.1.1 (a) (i))

Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced at sill (7.1.1 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

plastic sill covers fitted

Offside Seat belt anchorage prescribed area is corroded but not considered excessive at sill (7.1.1 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Lower Tie bar/rod has excessive play in a pin/bearing inner bearing (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement front bush (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement front bush (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Front brake discs corroded