2004 Mercedes-benz Vito

Covers Fitted On Sills (Inner & Outer) & Heavy Underseal

Engine Covers / Under-trays Fitted

Under-chassis, Suspension, Exhaust & Brake components corroded.

Vehicle is Heavily Under-sealed.

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Service brake efficiency below requirements (1.2.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Direction indicator slightly discoloured Both front (4.4.3 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp has a product on the lens but not seriously reducing light output Both (4.1.4 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Tyre worn close to legal limit/worn on edge Both front (5.2.3 (e))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pipe excessively corroded both (1.1.11 (c))

Position lamp not working Both front (4.2.1 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Vehicle structure has slight corrosion Jacking point (6.1.B.2)

Tyre worn close to the legal limit All four (4.1.E.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Suspension component mounting prescribed area is excessively corroded Centre (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded Centre (2.4.A.3)

Front Vehicle structure has slight corrosion Nearside and Offside jacking area (6.1.B.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit inner edge (4.1.E.1)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim too low (1.8)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake hose slightly deteriorated both side (3.6.B.4d)

general corrision under body

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)