2005 Mazda 6

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Suspension component corroded but not seriously weakened all (5.3.3 (b) (i))

rear inner sills covered heavily with sealant

Nearside Front Brake pad(s) wearing thin 80/ worn (1.1.13 (a) (ii))

Nearside Rear Parking brake is low, Met minimum Requirement, Repair or adjustment needed

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing Arm bush (5.3.4 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine light on

Nearside Front Brake pad(s) wearing thin 80/ worn (1.1.13 (a) (ii))

Nearside Rear Parking brake is low, Met minimum Requirement, Repair or adjustment needed

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing Arm bush (5.3.4 (a) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre tread depth below requirements of 1.6mm 205/55/16 (4.1.E.1)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)