2008 Toyota Aygo

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security ALL OVER (6.2.2 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Coil spring corroded BOTH SIDES (5.3.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened BOTH SIDES (5.3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security ALL OVER (6.2.2 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Central Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sill (6.1.1 (c) (i))

Offside Front Brake drum worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Seat belt slightly damaged (7.1.2 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Exhaust mounting defective (6.1.2 (a))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Seat belt slightly damaged (7.1.2 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Centre Exhaust system not adequately supported (7.1.1)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)