2005 Ford Connect

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split and allowing dirt to enter (6.1.7 (g) (ii))

Nearside Front Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))

Offside Front Headlamp insecure (4.1.1 (c))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure outer wall and also bulging (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed inner shoulder (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Headlamp aim too low both head lamps aim low (4.1.2 (a))

Front Headlamp lens slightly defective both front headlamp lenses discoloured/oxidised, this is beginning to affect beam images (4.1.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front washer jet partially blocked

Offside Rear lamp assembly lens cracked/damaged

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) both off side front and near side front ()

Power steering close to minimum mark (2.1.5 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Tyre slightly damaged/cracking or perishing rear inner tyre walls cracking/perishing (5.2.3 (d) (ii))

brake pedal anti slip surface worn

power steering pipe(s) adrift behind front bumper

rear high level stop lamp not working

steering rack body covered in oil

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases (7.1.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

rear leaf springs rusty

steering rack damp

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Lower Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

o/s/r tyre cracking on side wall

rear leaf springs rusty

steering rack damp

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Battery insecure (1.9.1)

Brake fluid warning lamp illuminated (3.6.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Centre Rear Stop lamp not working (1.2.1b)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too low (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

advise o/s/r bumper end cap missing