2005 Vauxhall Vivaro

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive jack point (5.3.6 (a) (i))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front Seat belt stitching slightly frayed (5.2.2b)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front wheel bearing has slight play (2.5.A.3c)

slight play rack

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Headlamp aim not tested (1.8.A.1c)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)