2008 Subaru Outback

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

centre and rear exhaust has slight blow

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central exhaust has slight blow

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Rear exhaust has slight blow

Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Inner Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Inner Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

engine management light on

Parking brake lever has little reserve travel (3.1.6b)

complete underside of vehicle very corroded and in need of attention

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Fuel cap/sealing device missing (7.2.4a)

Nearside Front Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

complete underside of vehicle very corroded and in need of attention

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both front D bushes (2.4.G.2)

Brake pad(s) wearing thin both front (3.5.1g)

Brake pad(s) wearing thin both rear (3.5.1g)

Suspension arm rubber bush deteriorated but not resulting in excessive movement both front bottom arm rear bushes (2.4.G.2)

brake disc worn, pitted or scored, but not seriously weakened both front (3.5.1i)

brake disc worn, pitted or scored, but not seriously weakened both rear (3.5.1i)

engine covers fitted

sill covers fitted

under tray fitted

Offside Front Front position lamp(s) not working (1.1.A.3b)

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both front D bushes (2.4.G.2)

Brake pad(s) wearing thin both front (3.5.1g)

Brake pad(s) wearing thin both rear (3.5.1g)

Suspension arm rubber bush deteriorated but not resulting in excessive movement both front bottom arm rear bushes (2.4.G.2)

brake disc worn, pitted or scored, but not seriously weakened both front (3.5.1i)

brake disc worn, pitted or scored, but not seriously weakened both rear (3.5.1i)

engine covers fitted

sill covers fitted

under tray fitted

Headlamp aim too low (1.8)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Both rear brake discs parcially corroded.

Front brake discs and pads wearing thin.