2014 MG 6

cannot see condition of components or brake pipes as covered in heavy under seal

Offside Front Electrical wiring heavily deteriorated rubbing on wheel (4.11 (b) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

cannot see condition of components or brake pipes as covered in heavy under seal

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside front Road Wheel Rubbing On Inner Arch

Vehicle Heavily Under Sealed

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

handbrake only just met requirements

n/s/f dip beam has poor pattern

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Headlamp aim too high (4.1.2 (a))

Front Brake pad(s) wearing thin Pad material starting to wear low (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre inner edge unevenly worn