MOT Status
ExpiredMileage
171,217 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Front front brake application uneven (3.7.B.2)
Nearside Inner Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)
Nearside Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)
Nearside Rear Seat belt anchorage prescribed area is excessively corroded sill end / wheel arch (5.2.6)
Nearside Stop lamp not working (1.2.1b)
Offside Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)
Offside Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)
Front position lamp(s) deteriorated, but still visible from a reasonable distance both front (1.1.A.3d)
Fuel filler neck mounting not connected, neck slightly loose
Nearside Front Outer tyre cut
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)
Nearside Rear seat belt not tested
Nearside parking brake lever on caliper not returning to the stop position
Nearside parking brake not working
Offside Front wing corroded but not considered sharp
Offside front brake fluctuating, but not excessively (3.7.B.3)
Rear Brake pad(s) wearing thin (3.5.1g)
Rear Suspension arm corroded but not seriously weakened (2.4.G.1)
Rear Suspension component mounting prescribed area is corroded but not considered excessive sills (2.4.A.3)
Tyre worn close to the legal limit both front (4.1.E.1)
Centre Rear Statutory seat belt missing not accessible (5.1.1)
Nearside Rear Body has a sharp edge caused by corrosion strongly advise taping (6.1.C.1)
Nearside Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)
Parking brake: efficiency below requirements (3.7.B.7)
Rear Exhaust system not adequately supported (7.1.1)
Registration plate lamp not working (1.1.C.1d)
Front position lamp(s) deteriorated, but still visible from a reasonable distance both front (1.1.A.3d)
Fuel filler neck mounting not connected, neck slightly loose
Nearside Front Outer tyre cut
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)
Nearside Rear seat belt not tested
Nearside parking brake not working
Offside Front wing corroded but not considered sharp
Offside front brake fluctuating, but not excessively (3.7.B.3)
Rear Brake pad(s) wearing thin (3.5.1g)
Rear Suspension arm corroded but not seriously weakened (2.4.G.1)
Rear Suspension component mounting prescribed area is corroded but not considered excessive sills (2.4.A.3)
Tyre worn close to the legal limit both front (4.1.E.1)
Bonded suspension unit deteriorated but can function as intended (2.4.F.3)
Nearside Outer Front Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Rear Suspension arm corroded but not seriously weakened (2.4.G.1)
Centre Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)
Offside Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)
Offside Outer Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)
Bonded suspension unit deteriorated but can function as intended (2.4.F.3)
Nearside Outer Front Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Rear Suspension arm corroded but not seriously weakened (2.4.G.1)
Nearside Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)
Offside Lower Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)
Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)
Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Bonded suspension unit deteriorated but can function as intended (2.4.F.3)
Nearside Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)
Offside Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)
Brakes imbalanced across an axle (3.7.B.5b)
Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)
Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)
Rear Upper Brake pipe inadequately clipped (3.6.B.1)
rear brake application uneven (3.7.B.2)
rear brakes release unevenly (3.7.B.4)
Bonded suspension unit deteriorated but can function as intended (2.4.F.3)
Nearside Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)
Offside Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)
Front registration plate deteriorated (6.3.1d)
Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)
Offside Rear Upper Brake pipe excessively corroded (3.6.B.2c)
Nearside Rear Brake pipe slightly corroded (3.6.B.2c)
Front registration plate deteriorated but not likely to be misread (6.3.1d)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Nearside Front constant velocity joint gaiter split (2.5.C.1a)
Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Nearside Front Brake pad(s) wearing thin (3.5.1g)
Suspension joint nearside lower dust cover split/missing
Nearside Rear brake disc slightly scored (3.5.1h)
Nearside Rear rear brake grabbing slightly (3.7.A.5b)
Offside Front Front constant velocity joint gaiter split (2.5.C.1a)
Brakes imbalanced across an axle (3.7.B.5b)
Offside Front front brake binding (3.7.B.1)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
How Reliable is the Mazda 6?
Based on 1,904,140 MOT tests across 159,651 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
VN52 YLH is a 2003 Mazda 6 in Silver with a 1,999cc petrol engine. This vehicle has been through 20 MOT tests with a personal pass rate of 55%.
Across all 2003 Mazda 6 models, the average MOT pass rate is 71.6% with a typical mileage of 83,392 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Mazda 6 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 45,082 recorded failures. If you're considering buying VN52 YLH, it's worth having these areas checked by a mechanic before committing.
The Mazda 6 typically stays on UK roads for around 24 years. At 23 years old, this Mazda 6 is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of VN52 YLH?
You can check the full history of VN52 YLH by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was VN52 YLH registered?
VN52 YLH is a 2003 Mazda 6, first registered on 31 January 2003.
Is VN52 YLH safe to buy?
The MOT history for VN52 YLH shows 20 tests with a 55% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does VN52 YLH have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on VN52 YLH. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.