2003 Audi A3

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Headlamp aim too low both (4.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

engine management light

Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

slight ply rear hubs

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

slight ply rear hubs

Nail in nearside rear tyre

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

cracks on both rear tyres

engine management light on

n/s/f tyre outer sidewall damaged

n/s/r outer sidewall damaged

o/s stop lamp dull

rear tyres getting low