2013 Ducati M

Clutch lever end broken

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Clutch lever end broken

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Number plate loose

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Clutch fluid level not visible in reservoir, lever action spongy

Clutch lever shortened (6.2.7 (b))

Front Brake hose attachment bracket on the top yoke loose/bolt not fully screwed in

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Registration plate lamp insecure Zip-tied (4.7.1 (c) (i))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake pedal anti-slip provision missing (1.1.2 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Clutch fluid level not visible in reservoir, lever action spongy

Clutch lever shortened (6.2.7 (b))

Front Brake hose attachment bracket on the top yoke loose/bolt not fully screwed in

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Registration plate lamp insecure Zip-tied (4.7.1 (c) (i))

Clutch lever shortened (6.2.7 (b))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Front Brake indicates excessive fluctuation of brake effort (1.2.1 (e))

Rear Brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Registration plate lamp does not illuminate simultaneously with the position lamp(s) (4.7.2 (a))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Front tyre unevenly worn across tread.

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Registration light does not work (4.7.1 (b) (ii))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Wheel alignment slightly misaligned (2.4 (a))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front wheel bearings are excessively rough (2.3.5b)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear Rear reflector on motorcycle missing (1.4.1)