2003 Mazda Bongo

Brake hydraulic reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Brake performance unable to be tested (1.2.1 (g))

Electronic braking system warning device indicates a fault (1.7 (b))

Hazard warning lamps inoperative (4.4.1 (e))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis (6.1.1 (c) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Offside Rear Hydraulic brake calliper leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

corrosion evident throughout vehicle structure

Offside Front Suspension rod ball joint has slight play (5.3.4 (a) (i))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner sill (6.1.1 (c) (i))

underside has advancing corrosion

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill corroded and holed (6.1.1 (c) (i))

underside showing signs of corrosion

Fluid leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Inner Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Fluid leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Inner Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front Outer Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp aim too far to the left (4.1.2 (a))

Central Exhaust system insecure exhaust bracket (6.1.2 (a))

Nearside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Front radiator support bar corrosion

Front Subframe mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear position lamp(s) has light sources not illuminating, but not more than 50% inner sidelight not working and lens damaged (1.1.A.3b)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Spare tyre defective deflated ()

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Subframe mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear position lamp(s) has light sources not illuminating, but not more than 50% inner sidelight not working and lens damaged (1.1.A.3b)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Spare tyre defective deflated ()

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Rear fog lamp not working (1.3.2b)

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Rear wiper blade breaking up

Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Stop lamp not working (1.2.1b)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Oil leak