2003 Fiat Doblo

Central Rear Seat belt buckle not functioning as intended (7.1.2 (d))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Direction indicator adversely affected by the operation of another lamp (4.4.3 (b))

Nearside Rear Inner Anti-roll bar pin or bush excessively worn Above fuel tank. (5.3.4 (a) (i))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis rail. (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill. (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill. (5.3.6 (a) (i))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake load sensing valve linkage obviously incorrectly adjusted (1.1.17 (b))

Registration plate lamp inoperative in the case of a single lamp or all lamps 2 x rear. (4.7.1 (b) (ii))

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pad(s) wearing thin All front brake pads getting low. (1.1.13 (a) (ii))

Brake pedal wearing smooth (1.1.2 (c))

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Engine - Rear torque reaction member bush worn.

Exhaust has a minor leak of exhaust gases Front pipe flexible joint. (6.1.2 (a))

Lower engine bay cover installed obscuring testable components.

Nearside Front Brake hose slightly chafed Hose not correctly seated in mounting. (1.1.12 (b) (i))

Nearside Front Nail in tyre ()

Nearside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material From engine bay into wheel housing. (1.1.11 (c))

Rear Axle corroded but not seriously weakened.

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Behind fuel tank. (6.1.1 (c) (i))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Inner Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Rear Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Nearside Rear Inner Vehicle structure is deformed and structural rigidity is significantly reduced after rear wheel (6.1.1 (a) (i))

Offside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Lower Vehicle structure is deformed and structural rigidity is significantly reduced rear after wheel (6.1.1 (a) (i))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Anti-roll bar linkage ball joint has slight play both sides (5.3.4 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Windscreen washer not working (3.5 (a))

Nearside Rear Tyre slightly damaged 175/70r14 (5.2.3 (d) (ii))

Nearside Rear brake binding slightly

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear brake binding slightly

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake pipe slightly corroded Front to rear x2 (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Registration plate lamp not working (1.1.C.1d)

front brake discs pitted on inner surfaces

front tyre bald on edges offside front 0.mm useable tread left 175 70 14 t

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside rear brake application uneven (3.7.B.2)

Offside Headlamp not working on dipped beam (1.7.5a)

exhaust rear silencer corroding

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

exhaust catalist & system corroded

rear tyres 3 mm 175 70 14 t

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

exhaust catalist & system corroded

rear tyres 3 mm 175 70 14 t

Front Headlamp aim too low (1.8)