2001 Mercedes-benz Vito

Nearside Front Tyre fouling a part of the vehicle (5.2.3 (f))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Crossmember by tow bar mounting (6.1.1 (c) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Crossmember buy towbar mounting (6.1.1 (c) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Side repeater incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Offside Track rod end ball joint has slight play (2.2.B.1f)

inner / outer sills beginning to corrode at front

Offside Track rod end ball joint has slight play (2.2.B.1f)

corrosion to both inner / outer sill panels at front

wear / corrosion to rear brake discs

wear to front tyres -n/s on limit