2001 Toyota Yaris

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength offside and nearside rear axle (5.3.6 (a) (i))

Nearside Front Lower Anti-roll bar linkage pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Suspension component corroded but not seriously weakened offside and nearside (5.3.3 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component corroded but not seriously weakened rear axle and underbody (5.3.3 (b) (i))

Front Anti-roll bar ball joint dust cover severely deteriorated Both sides (5.3.4 (b) (i))

Front Subframe corroded but not excessively

Rear Shock absorbers has a reduced damping effect Both sides (5.3.2 (d))

Rear Subframe corroded but not excessively

Rear Subframe mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Rear Coil spring corroded Both Sides (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Front Registration plate insecure (0.1 (a))

Front Windscreen washer not working (3.5 (a))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Front fog lamp not working (4.5.1 (a) (ii))

Rear Coil spring corroded Both Sides (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever defective so that it cannot be satisfactorily operated (1.1.6 (d))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

hand brake long travel

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Direction indicator insecure (4.4.1 (c) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Direction indicator insecure (4.4.1 (c) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Parking brake lever ratchet not holding correctly (1.1.6 (a))

Parking brake lever has little reserve travel (3.1.6b)

wipers poor

Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nail in offside rear tyre

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside rear brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nail in offside rear tyre

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Front Headlamp aim too low (1.8)

Rear Registration plate lamp not working (1.1.5c)