2002 Mazda MX-5

Nearside Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced Sill To Floor (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material Both Sides (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Lower Integral body structure is corroded but structural rigidity is not significantly reduced Sill To Floor (6.1.1 (c) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

front body damage to bumper

n/s/front tyre slight outer wall damage

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Registration plate lamp not working (1.1.C.1d)

front body damage to bumper

n/s/front tyre slight outer wall damage

Front Brake pad(s) wearing thin (3.5.1g)

brake fluid low

cut in n/s/front outer tyre wall

engine management light

n/s wiper smears screen

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Brake pad(s) wearing thin (3.5.1g)

brake fluid low

cut in n/s/front outer tyre wall

engine management light

n/s wiper smears screen

Cannot clearly see front or rear inner brake pads

Engine management light on

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brakes binding on slightly

N/S/R tyre sidewall thin

Nearside Front position lamp(s) not working (1.1.A.3b)

engine management light on

engine management light on

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)