2008 Subaru Legacy

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Outer sills covered in plastic

suspension components corroded in parts

Nearside Headlamp aim too low (1.8)

Offside Stop lamp not working (1.2.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

damage to nearside front tyre sidewall