2009 Hyundai I10

Front Anti-roll bar linkage ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened Offside + Nearside. (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement Offside + Nearside. (5.3.4 (a) (i))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded Offside + Nearside. (5.3.1 (b) (i))

Central Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Outer Tyre worn close to legal limit/worn on edge Edges (5.2.3 (e))

Offside Rear Outer Tyre worn close to legal limit/worn on edge Edges (5.2.3 (e))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Outer Tyre worn close to legal limit/worn on edge Edges (5.2.3 (e))

Offside Rear Outer Tyre worn close to legal limit/worn on edge Edges (5.2.3 (e))

Offside Brake cable insecure (3.5.1d)

Offside park cable being insecure has caused damage to outer cable due to cable rubbing on axle mounting,water ingress is likely.

two LEDs in high level stop light are inoperative.