2010 Toyota Auris

Brake pipe corroded, covered in grease or other material Various (1.1.11 (c))

General corrosion to the under-body and suspension components

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Parking brake lever worn, but not excessively (1.1.6 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Rear Child Seat fitted not allowing full inspection of adult belt

Central Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated inner (6.1.7 (g) (i))

Nearside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Nearside Side repeater with a multiple light source up to 1/2 not functioning (4.4.1 (a) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Child Seat fitted not allowing full inspection of adult belt

Nearside Front Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Rear Brake disc significantly and obviously worn both side (1.1.14 (a) (i))

Rear Brake pad(s) worn down to wear indicator both side (1.1.13 (a) (i))

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Rear Hydraulic brake calliper excessively weakened by corrosion both side (1.1.16 (d) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin both sides rear (1.1.13 (a) (ii))

Rear Brake disc worn, but not excessively both sides (1.1.14 (a) (i))

Rear Coil spring corroded both rear (5.3.1 (b) (i))

Front Play in steering rack inner joint(s)

Front both side top muontin shoker slightly worn but not excesssives

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pivot corroded but not seriously weakened HAND BEARK cable slitly high (1.1.15 (b))

Rear Shock absorbers has a reduced damping effect both side (5.3.2 (d))

Offside Rear Brake lining(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Front Exhaust system insecure (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake lining(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake lining(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Exhaust mounting defective (6.1.2 (a))

Exhaust system insecure (6.1.2 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear exhaust shield insecure

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre wearing inside edge

Offside Rear Tyre wearing inside edge

engine covers/undertrays fitted

front discs corroded on inner edges

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front discs corroded on inner edges