2003 Lexus RX300

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outersill (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill. (5.3.6 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Both front suspension lower arm bushes old and perished

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

General underbody corrosion

Nearside Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill old and corroded. (6.2.2 (d) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Both front suspension lower arm bushes old and perished

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

General underbody corrosion

Nearside Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill old and corroded. (6.2.2 (d) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Offside Front Windscreen wiper blade defective (3.4 (b) (i))

General under body corrosion rear axle

Offside Rear Exhaust mounting defective corroded loose. (6.1.2 (a))

Front Headlamp has a product on the lens but not seriously reducing light output Both front lamps very cloudy (1.7.5a)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' Stone chip present (8.3.1a)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Nail in tyre near to edge ()

engine mill lamp on

Engine cover fitted.

Under-tray fitted.

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Engine cover fitted.

Headlamp aim too low (1.8)

Under-tray fitted.

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake pads

front numberplate

unable to fully inspect rear brake linings

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)