2005 Jaguar S-type

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Rear Suspension arm ball joint dust cover no longer prevents the ingress of dirt upper arm dust cover (5.3.4 (b) (ii))

Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Offside Rear Suspension arm ball joint dust cover no longer prevents the ingress of dirt upper arm dust cover (5.3.4 (b) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure inner side wall where chalked 2013 dot code (5.2.3 (d) (ii)) DANGEROUS

245 40 r 18 97 w xl

Nearside Front Headlamp lens slightly defective both unit lenses dip and main (4.1.1 (b) (i))

Nearside Front Tyre slightly damaged/cracking or perishing 2014 dot code cracking badly (5.2.3 (d) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing 2014 dot code cracking badly (5.2.3 (d) (ii))

Offside Front Headlamp lens slightly defective both unit lenses dip and main (4.1.1 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing 2014 dot code cracking badly (5.2.3 (d) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view chip outside zone a (3.2 (a) (i))

brake pedal spongy at times

eml light displayed pre july 2008

engine covers and undertrays fitted

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Outer Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Outer Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Nearside Rear Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Outer Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Outer Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim too high (1.8)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)