2004 Skoda Fabia

rear exhaust box rusty

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

rear exhaust box rusty

Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

rear exhaust box rusty

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

rear exhaust box rusty

rear exhaust box rusty

Brake lever has insufficient reserve travel (1.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

rear exhaust box rusty

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Suspension arm rubber bush deteriorated resulting in excessive movement both (2.4.G.2)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Front Headlamp deteriorated but light output not reduced (1.7.5a)

rear tailbox corroded

Nearside Front Upper Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Headlamp aim too low (1.8)

Front Headlamp deteriorated but light output not reduced (1.7.5a)

rear tailbox corroded

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rear tyres cracked both

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)