2007 Aprilia RS125

Front fork seals worn

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

rear number plate obstructing indicators but still visible

rear seat missing

rear tyre worn/perrished

registration plate lamp poor

Rear Brake pedal pivot has excessive free play (1.1.1 (b))

Front fork seals worn

Offside Handlebar mounting insecure (2.2.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

rear lamp lens loose

rear number plate obstructing indicators but still visible

rear seat missing

rear tyre worn/perrished

registration plate lamp poor

All direction indicators not working (4.4.1 (a) (ii))

Rear Lower Shock absorber has an excessively worn bush (5.3.2 (c))

Rear Suspension component pin or bush excessively worn (5.3.4 (a) (i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

exhaust fouls swinging arm

Front Brake component is excessively corroded brake pads seperated. (3.1.5)

Front Floor brake test indicates a binding brake (3.3.C2c)

Front position lamp does not illuminate immediately when switched on side lights (1.1.3a)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride split link clip missing. (6.2.1h)

Offside Rear Footrest missing (6.2.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

exhaust fouls swinging arm

Rear suspension bush has slight free play (2.4.A2a(i))

number plate light not working

Throttle operating incorrectly (6.2.1f)

Rear suspension bush has slight free play (2.4.A2a(i))

number plate light not working

Brake lever is bent but brake can still be readily applied (3.1.3c)

Brake pedal is bent but brake can still be readily applied (3.1.3c)

Drive chain slightly loose (6.2.1d)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Headlamp damaged but function not impaired (1.2.3a)

See seperate advisory sheet

Brake pedal has inadequate reserve travel (3.1.3b)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Handlebar mounting clamp bolt loose (2.1.1a)

Rear Brake pad(s) close to minimum limit (3.2A1f(ii))