2012 MG 6

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Rear Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Inner Tyre worn close to legal limit/worn on edge Both sides (5.2.3 (e))

Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Brake pipe corroded, covered in grease or other material Front - Rear and o/s/f slightly corroded (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear Bush (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin Appear to be (1.1.13 (a) (ii))

Under body covers fitted

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit and bald on inner shoulder (4.1.E.1)

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement D bushs (2.4.G.2)

n/s/f tyre worn inside edge