2003 Hyundai Getz

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases flexi (6.1.2 (a))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Registration plate insecure (0.1 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Drive shaft joint constant velocity boot severely deteriorated both (6.1.7 (g) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Front Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever defective so that it cannot be satisfactorily operated high (1.1.6 (d))

Offside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Drive shaft joint constant velocity boot severely deteriorated both (6.1.7 (g) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both rear arches (6.2.2 (d) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Parking brake lever defective but can be satisfactorily operated high (1.1.6 (d))

Nearside Rear tyre wearing / worn on edge

oil leak from oil filter

Tyre worn close to the legal limit Both front (4.1.E.1)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm 165/65/14 (4.1.E.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded Outer sill (5.2.6)

Handbrake travel

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres are cracking in tread

offside rear shock absorber is damp

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Steering rack gaiter insecure (2.2.D.2d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Steering rack gaiter insecure (2.2.D.2d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

both front outer cv joint gators deteriorated

nearside front brake pad back plate scrubbing on cv joint

nail in offside rear tyre

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper blade insecure (8.2.2)

nail in offside rear tyre