2013 Mercedes-benz Sprinter

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Nail in tyre ()

Park brake has very long travel

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Park brake has very long travel

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Tyre has a cut but not deep enough to reach the ply or cords Both NSR OSR (5.2.3 (d) (i))

Spare tyre defective ()

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Spare tyre defective ()

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Brake pipe excessively corroded front to rear (1.1.11 (c))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Position lamp not working (4.2.1 (a))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front pads low

Handbrake lever has little reserve travel

Offside rear tyre worn close to the legal limit

Rear pads low