2000 Toyota Yaris

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Headlamp lens slightly defective lens oxidised (4.1.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp lens slightly defective lens oxidised (4.1.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

puncture hole in nsr floor

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

nearside rear floor holed but not in testable area

Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

nearside rear floor holed but not in testable area

E.M.L

Offside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Battery insecure (1.9.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear coil spring incomplete (2.4.C.1a)

Stop lamp not working (1.2.1b)

Vehicle's internal headlight adjuster altered to recheck lights

engine warning light on

Parking brake lever has little reserve travel (3.1.6b)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too low (1.8)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

hole to n/s/r floor pan suggest welding