2000 Toyota Yaris

Vehicle structure is corroded but structural rigidity is not significantly reduced Slight surface rust (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced Slight surface rust (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Direction indicator incorrect colour (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too low (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Rear coil spring broken (2.4.C.1a)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring broken (2.4.C.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage fractured (2.4.G.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Rear registration plate deteriorated (6.3.1d)

o/s+n/s/r tyres outer walls cracking

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Registration plate lamp not working (1.1.C.1d)

Offside Front Brake pad(s) wearing thin (3.5.1g)