2000 Ford Fiesta

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Headlamp aim too high (1.8)

Nearside Rear Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake hose excessively chafed (3.6.B.4d)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Headlamp aim too low (1.8)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Rear Brake pipe inadequately clipped (3.6.B.1)

Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Corrosion present under vehicle and on offside rear wheel arch.

Rear Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

Rear steel brake pipe clips missing.

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Headlamp not working on dipped beam (1.7.5a)

Corrosion present under vehicle and on offside rear wheel arch.

Rear Exhaust system not adequately supported (7.1.1)

Rear Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

Rear steel brake pipe clips missing.

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Outer Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside outer sill panel rusty by drivers seatbelt anchorage point

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)