2000 Honda CB600

NO INDECATORS FITTED AT TIME OF TEST

NO INDECATORS FITTED AT TIME OF TEST

Rear reflector missing (4.8.2 (a) (ii))

Rear Position lamp light intensity obviously reduced NONE TYPE APROVED LAMP FITTED (4.2.3 (a) (i))

Rear Footrest missing (6.2.12 (a))

Rear Position lamp light intensity obviously reduced NONE TYPE APROVED LAMP FITTED (4.2.3 (a) (i))

Rear reflector missing (4.8.2 (a) (ii))

Front Brake excessively binding (1.2.1 (f))

Rear reflector missing (4.8.2 (a) (ii))

Front Brake excessively binding (1.2.1 (f))

Headlamp aim too low (4.1.2 (a))

Rear reflector missing (4.8.2 (a) (ii))

Front Valve stem seriously damaged (5.2.3 (j)) DANGEROUS

Rear Valve stem seriously damaged (5.2.3 (j)) DANGEROUS

Throttle control functioning such that safe operation of the motorcycle is adversely affected (6.2.7 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake disc(s) slightly worn (3.2.A1l)

Drive chain excessively tight (6.2.1d)

Drive chain sprocket carrier worn to excess bearing (6.2.1e)

Front Front wheel bearings have excessive free play (2.3.5b)

Front wheel bearings are excessively rough (2.3.5b)

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front wheel bearings have slight free play (2.3.5b)

Rear Brake disc(s) slightly worn (3.2.A1l)

Front wheel bearings have slight free play (2.3.5b)

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Offside Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Drive belt slightly loose (6.2.1d)

Front suspension has a slightly reduced damping effect (2.3.6c)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive belt slightly loose (6.2.1d)

Front suspension has a slightly reduced damping effect (2.3.6c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear reflector on motorcycle missing (1.4.1)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear wheel bearings have excessive free play (2.4.A.2c)

Throttle operating incorrectly (6.2.1f)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))