2000 Ford Focus

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sills (6.2.2 (d) (i))

Rear Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both trailing arm bushes (5.3.4 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Central Exhaust system insecure exhaust sheild (6.1.2 (a))

Headlamp aim too high both (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Upper Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust emits clearly visible black smoke during acceleration (8.2.1.2 (g))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Anti-roll bar linkage pin or bush excessively worn d bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Rear Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

rear heat shield insecure

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded n/s and o/s (5.3.1 (b) (i))

Nearside Rear Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded n/s and o/s (5.3.1 (b) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear An item not tested (Manual)

o/s rear tyre has a cut / lump missing in the tread

NSR tyre is worn unevenly and misshaped